Personal tools

Sections
Print this  

LOw Frequency ARray (LOFAR)

LOw Frequency ARray (LOFAR)

LOFAR is a novel radio telescope that operates in the frequency range of 30 MHz - 240 MHz. It is currently being constructed by ASTRON at Exloo in the Netherlands. In its first construction phase it consists of about 40 sensor arrays. 20 of them form a compact core at Exloo with a diameter of 2 km. 20 stations are located farther away and approximately form logarithmic spirals in the northern Netherlands. This configuration reaches baselines of about 100 km.

A LOFARstation consists of two arrays of antennae for low (30 MHz - 80 MHz) and high (120 MHz - 240 MHz) frequencies, respectively. The antennae are simple dipole antennae. The gap between 80 MHz and 120 MHz avoids the FM radio range that inhibits observations with its strong background signals.

In "classical" radio interferometers an array of radio dish antennae is oriented towards the observed source in the sky. The antenna signals are correlated with well-defined delays, and an image is synthesized. With this setup, only a single source can be observed at a certain frequency at the same time. LOFARpursues a different approach that offers an unprecedented flexibility and versatility. LOFARuses arrays of simple dipole antennae that essentially cover the whole sky. At each LOFARstation, the antenna signals are digitized, pre-processed and sent to the Central Processing System (CPS) at Groningen, where signal correlation and further data processing is done. This design provides LOFARwith high flexibility and enables the simultaneous observations of up to 8 different sources in the sky. The long baselines of LOFAR provide an angular resolution in the arc-second range, and the large collecting area of all LOFARstations combined leads to a sensitivity down to a mJy. Thus, considerably exceeds the capabilities of current radio telescopes both in resolution and sensitivity.

Table of Contents

LOFAR Key Science Projects

With its high sensitivity and flexibility, LOFARis well suited for a wide variety of scientific topics, from the early universe to Earth's space environment.  For radioastronomical observations with LOFAR, special emphasis is on the following "Key Science Projects":

  • Solar Physics and Space Weather
    The Sun is an intense radio source. Bursts of solar radio emission are closely connected to the phenomena of the active Sun, like flares and coronal mass ejections. The solar activity has strong implications on Earth and its space environment. These connections are summarized under the term space weather In the Key Science Project "Solar Physics and Space Weather with LOFAR" these phenomena are studied.
  • Epoch of Reionization
    LOFAR
    will observe the 21 cm line of neutral hydrogen from the epoch of reionization of the early Universe. This way, it will gain information on the first stars and galaxies, as well as on structure formation in the early Universe.
  • Deep Extragalactic Surveys
    LOFARwill map the sky with high sensitivity, and will provide catalogues of radio sources. The applications range from black holes over galaxies to galaxy clusters. Discoveries of new phenomena are expected.
  • Transient Events
    Regular monitoring of a large part of the sky will reveal variable radio sources, and leads to the discovery of transient events. Candidates for such radio outbursts are flare stars, X-ray binaries, supernovae, and gamma ray bursts.
  • Cosmic Magnetism
    Cosmic ray particles emit synchrotron radiation in the weak magnetic fields of galaxies, that is observable with LOFAR. This way, magnetic fields in distant galaxies can be determined, leading to new insights in galactic dynamics.
  • Ultra High Energy Cosmic Rays
    If a highly energetic cosmic ray particle hits an atom in Earth's atmosphere, a cascade of secondary particles is released. Such a cascade emits a flash of radio waves. LOFAR observations of these flashes shed light on the sources of cosmic rays.

Table of Contents

Solar radioastronomy with LOFAR

Solar radio emission in the LOFAR frequency range originates from the middle and upper corona. Thus, and with its imaging capability, LOFAR is well appropriate e.g. to study the release of coronal mass ejections (CMEs) and to estimate their potential impact on Earth. This is of great importance for space weather research.

At low frequencies, only a few instruments with imaging capability observe the Sun. E.g., the radioheliograph at Nancay, France, is operated on selected frequencies ranging from 150 MHz - 432 MHz and yields an image resolution of up to 1'. LOFAR will dramatically improve the situation with routine observations, and will expand the frequency range down to 30 MHz. With simultaneous observations at several frequencies, it will be possible to probe different heights in the corona, and to reveal structures in coronal radio sources that are yet unexplored. LOFAR's flexibility enables different observation modes that are tailored to different scientific objectives:

  • Response to solar radio bursts
    Since the control of LOFAR is basically realized in software, it is possible to react quickly on changes in the solar activity. If a continuously operated solar radio spectrometer, e.g. the Observatory for Solar Radioastronomy, detects a radio burst ("burst bell"), follow-up observations with LOFARcan be triggered, e.g. a rapid sequence of images in different frequencies.
  • Routine monitoring of the solar activity
    Continuous monitoring of the Sun allows for studies of the long-term evolution of solar active regions and provides information on the precursors of solar radio bursts, flares, and CMEs. Continuous imaging would comprise an sequence of 1 image per minute. Such observations can be ideally combined with optical images, like the H alpha images of the Kanzelhöhe Solar Observatory.
  • Space weather studies
    The phenomena of the active Sun, like flares and CMEs, can have severe impact on the terrestrial environment. This relationship is usually referred to as Space Weather. LOFAR's frequency range covers radio source locations in the upper corona, this is the region where CMEs start towards interplanetary space. With LOFAR images of a nascent CME it is possible to estimate its potential impact on Earth.
  • Observation campaigns
  • Simultaneous observations at different wavelength ranges are useful for a better understanding of the physical processes in flares and CMEs. Highly energetic electrons in the solar atmosphere do not only emit radio waves, but also X-rays, while the heating of the corona in a flare leads to EUV emission, and the effects of a flare on the chromosphere are observable in optical and millimeter wavelengths. Thus, joint observation campaigns with X-ray telescopes like NASA's RHESSI, the Japanese Hinode or Solar Dynamics Observatory of NASA, are as reasonable as with optical telescopes like GREGOR or millimetre wave telescopes like ALMA.
  • For CME studies, joint observations with LOFAR and space-based radio receivers are useful, since the frequency of CMEs radio emission decreases with increasing distance from the Sun, and ground-based observations of frequencies below 10 MHz are not possible due to ionospheric reflection. An example for such a space mission is STEREO.
  • Single station as a spectrometer
    Beside of the previously presented observation modes that make use of the whole LOFAR system for image synthesis, there is also the possibility to use only a single station for solar observations. This could be possible if e.g. a LOFAR observing program only uses the central core, and remote stations like that at Bornim are available. In this case, the radio spectrum of the Sun is observed in selected frequency intervals starting from 30 MHz. Such a program makes optimal use of the resources of the LOFAR telescope.


More information on solar radio astronomy with LOFAR is available in our brochure Solar Physics with LOFAR (PDF, 1071 KB).

Table of Contents

Further scientific interest in  LOFAR at the AIP

LOFAR is a powerful and flexible radiotelescope that is useful for many scientific applications. Both research areas of the AIP have the following interests beside solar physics:

  • Solar-stellar connections
    The Sun is the only star that can be observed directly from Earth with imaging telescopes. Investigation of the Sun as a typical main sequence star is thus of great interest for stellar astrophysics.
  • Extragalactic astronomy
    LOFAR is capable of observing the formation and evolution of galaxies, galaxy clusters, and active galactic nuclei (AGNs), as well as the epoch of reionization of matter in the early Universe due to the UV light of the first stars and quasars.
  • Galactic astronomy
    With LOFAR it will be possible to study the absorption and polarization of radio waves in the interstellar medium, as well as shocks and particle acceleration at supernova remnants.
  • All sky surveys
    LOFAR will produce radio maps of the whole sky visible from Central Europe with unprecedented sensitivity and angular resolution. The discovery of many new objects can be expected.
  • GRID computing
    LOFAR observations produce large amounts of data. Their processing and storage requires a suitable infrastructure that is provided by GRID technology, e.g. dCache. Thus, GRID computing and E-science are essential components of the LOFAR project.

Table of Contents

LOFAR stations in Germany - GLOW

A group of German institutes interested in LOFAR, e.g. the AIP or the MPI for radioastronomy have founded the German LOng Wavelength consortium (GLOW).

Stations 2011


The previous picture shows a map of the LOFAR stations in Germany. With these and further stations all across Central Europe, baselines of up to 1000 km are reached, and LOFAR's angular resolution is further improved.

The LOFAR station at Effelsberg, that is run by the MPI for Radioastronomy, has recently started operations.

For further information on the LOFAR activities in Germany, see http://www.lofar.de.

Table of Contents

LOFAR Station at the AIP at Bornim

Table of Contents